Headlamp Replacement
Visual Aiming Preparation ProcedureInstallation Procedure
Cut the front compartment front rail in corresponding locations to fit
the remaining original panel. The sectioning joint should be
trimmed to allow a gap of one-and-one-half-times the metal thickness at the
sectioning joint.
Create a 50 mm (2 in) backing plate from the unused porti ...
Cigarette Lighter
For vehicles with a cigarette lighter, it is on the center floor console near
the shift lever.
To activate the cigarette lighter, push it into the heating element and let go.
When the lighter is ready it will pop back out.
Notice: Holding a cigarette lighter in while it is heating does not
l ...
Headlamp Mount Panel Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface sec ...