Chevrolet Cruze Repair Manual: Instrument Panel Wiring Harness Replacement
Removal Procedure
- Remove instrument panel compartment assembly. Refer to Instrument Panel Compartment Replacement.
- Remove instrument panel wiring harness (2) from instrument panel tie bar
(1).
Disconnect electrical connectors.
Installation Procedure
- Install instrument panel wiring harness (2) from instrument panel tie
bar (1).
Connect electrical connectors.
- Install instrument panel compartment assembly. Refer to Instrument Panel Compartment Replacement.
Instrument Panel Tie Bar Replacement (Right Hand Drive)
Removal Procedure
Remove instrument panel compartment. Refer to Instrument Panel
Compartment Replacement.
Remove instrument panel wiring harness (2) from instrument panel tie ba ...
Front Floor Console Storage Tray Replacement
Preliminary Procedure
Remove the automatic or manual transmission control lever trim cover. Refer
to Automatic or Manual Transmission Control Lever
Trim Cover Replacement
Front Floor Conso ...
Other materials:
Cigarette Lighter
For vehicles with a cigarette lighter, it is on the center floor console near
the shift lever.
To activate the cigarette lighter, push it into the heating element and let go.
When the lighter is ready it will pop back out.
Notice: Holding a cigarette lighter in while it is heating does not
l ...
Front End Upper Tie Bar Support Sectioning (MAG Welding)
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
W ...
Rear Suspension Description and Operation
This vehicle has a semi-independent twist-beam rear suspension system
consisting of the following components:
An axle with integral trailing arms
AV shaped twisting cross beam
Two coil springs
Two shock absorbers
Axle Assembly
The axle assembly (1) attaches to the underbody throu ...
