Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Remote Vehicle Start

For vehicles with this feature, the engine can be started from outside the vehicle.

Starting the Vehicle

1. Aim the RKE transmitter at the vehicle.

2. Press and release 3. Immediately after completing Step 2, press and hold.

3. Immediately after completing Step 2, press and hold turn signal lamps flash. for at least two seconds or until the turn signal lamps flash.

When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

Canceling a Remote Start

To cancel a remote start, do one of the following: • Aim the RKE transmitter at the vehicle and press and hold / until the parking lamps turn off.

• Turn on the hazard warning flashers.

• Turn the vehicle on and then off.

Remote Keyless Entry (RKE) System
The Remote Keyless Entry (RKE) transmitter may work up to 60m (195 ft) away from the vehicle. RKE Transmitter with Remote Start Shown Press the key release button to extend the key blade. The ke ...

Door Locks
To lock or unlock the vehicle from outside, use the Remote Keyless Entry (RKE) transmitter or the key. From inside the vehicle, use the power door lock switch. Power Door Locks : Press to unloc ...

Other materials:

Inflatable Restraint Side Impact Sensor Replacement
Warning: Refer to SIR Warning in the Preface section. Warning: Refer to SIR Inflator Module Handling and Storage Warning in the Preface section. Warning: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary: Th ...

Vehicle Load Limits
It is very important to know how much weight the vehicle can carry. This weight is called the vehicle capacity weight and includes the weight of all occupants, cargo, and all nonfactory-installed options. Two labels on the vehicle show how much weight it may properly carry: the Tire and Loadi ...

Installation Procedure
Align the rear compartment floor panel. Drill 8 mm (5/16 in) for plug welding along the edges of the rear compartment floor panel as noted from the original panel. Clean and prepare the attaching surfaces for welding. Position the rear compartment floor panel on the vehicle. V ...

© 2011-2026 Copyright www.ccruze.com