Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Servicing the Airbag-Equipped Vehicle

Chevrolet Cruze Owners Manual / Seats and Restraints / Airbag System / Servicing the Airbag-Equipped Vehicle

Airbags affect how the vehicle should be serviced. There are parts of the airbag system in several places around the vehicle. Your dealer and the service manual have information about servicing the vehicle and the airbag system.

WARNING

For up to 10 seconds after the vehicle is turned off and the battery is disconnected, an airbag can still inflate during improper service. You can be injured if you are close to an airbag when it inflates. Avoid yellow connectors.

They are probably part of the airbag system. Be sure to follow proper service procedures, and make sure the person performing work for you is qualified to do so.

Passenger Sensing System
The vehicle has a passenger sensing system for the front outboard passenger position. The passenger airbag status indicator will light on the instrument panel when the vehicle is started. Unite ...

Adding Equipment to the Airbag-Equipped Vehicle
Adding accessories that change the vehicle's frame, bumper system, height, front end, or side sheet metal, may keep the airbag system from working properly. The operation of the airbag system ...

Other materials:

Additional Maintenance and Care
Your vehicle is an important investment and caring for it properly may help to avoid future costly repairs. To maintain vehicle performance, additional maintenance services may be required. It is recommended that your dealer perform these services — their trained dealer technicians know your v ...

Front Wheel Drive Shaft Replacement - Right Side
Special Tools CH-313 Slide Hammer CH-6003 Axle Shaft Remover CH-49376 Holding Wrench CH-49400 Hub Spindle Remover DT-6332 Seal Protector EN-956-1 Extension For equivalent regional tools, refer to Special Tools. Removal Procedure Warning: To prevent personal injury and/or component ...

Installation Procedure
Position the lower control arm (1) in the cradle. Install and hand tighten the NEW rear lower control arm bushing nuts and bolts (1). Install and hand tighten the NEW front lower control arm nut and bolt (1). Caution: Refer to Fastener Caution in the Preface secti ...

© 2011-2026 Copyright www.ccruze.com