Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Steering

SIR Disabling and Enabling
SIR component location affects how a vehicle should be serviced. There are parts of the SIR system installed in various locations around a vehicle. To find the location of the SIR components refer ...

Power Steering
Specifications Power Steering System Bleeding Note: Use clean, new power steering fluid type only. See the Maintenance and Lubrication subsection for fluid specifications. Hoses tou ...

Other materials:

Installation Procedure
Cut the rear side rail in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused portion of the serv ...

Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located in the trunk, under the load floor, behind an access panel. To remove the kit: 1. Open the trunk. 2. Turn the left knob counterclockwise and the right knob clockwise, 90 degrees, at the same time. Then pull the access panel rearward and up to r ...

Turn Signal Switch Replacement
Preliminary Procedure Remove the steering column upper trim cover. Refer to Steering Column Upper Trim  Cover Replacement. Remove the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement. Turn Signal Switch Procedure Disconnect any elec ...

© 2011-2026 Copyright www.ccruze.com