Chevrolet Cruze Repair Manual: Fuel Tank Filler Pipe Housing Replacement
Preliminary Procedure
- Remove rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement.
- Remove fuel tank filler door. Refer to Fuel Tank Filler Door Replacement.
- Fuel Tank Filler Door Lock Actuator
Procedure
Disconnect electrical connector.
- Fuel Tank Filler Pipe Housing
Procedure
Unclip 4 clips and remove.
Tip
Push fuel tank filler door lock actuator locking rod in closed position.
Front Side Door Check Replacement
Prliminary Procedure
Remove front side door trim panel. Refer to Front Side Door Trim
Replacement
Remove the front side door water deflector. Refer to Front Side Door
Water Defle ...
Hood Hold-Open Rod Replacement
Warning: Refer to Hood Hold-Open Device Warning in the Preface section.
Preliminary Procedure
Remove the radiator grille reinforcement support. Refer to Radiator Grille
Reinforcement Support R ...
Other materials:
Passenger Airbag Status Indicator
The vehicle has a passenger sensing system.
The instrument panel has a passenger airbag status indicator.
United States
Canada
When the vehicle is started, the passenger airbag status indicator will light
ON and OFF, or the symbol for on and off, for several seconds as a system check.
If ...
Vehicle Data Recording and Privacy
The vehicle has a number of computers that record information about the vehicle’s
performance and how it is driven. For example, the vehicle uses computer modules
to monitor and control engine and transmission performance, to monitor the conditions
for airbag deployment and deploy them in a cr ...
Installation Procedure
Cut the quarter outer panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed to
allow a gap of one-and-one-half-times the metal thickness at the sectioning
joint.
Create a 50 mm (2 in) backing plate from the unused portion
&nbs ...
