Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Seat Belt System Description and Operation

Chevrolet Cruze Repair Manual / Seatbelts / Seat Belt System Description and Operation

Seat Belt Latch Stop Installation
Preliminary Procedure Locate the hole in the seat belt webbing where the original seat belt stop button was located. If the original hole in the seat belt webbing is not visible, perform ...

Restraint System
Note: If the vehicle has been in a collision, refer to Repairs and Inspections Required After a Collision for additional information. Vehicle has front and rear seat belts that are the primary mean ...

Other materials:

Installation Procedure
Align the front side door outer panel. Verify the fit of the front side door outer panel. Clamp the front side door outer  panel into position. Pre-flanging the flange with BO-6396 pliers and BO-6392 tool kit . Continue to hammer in stages along the hem flanges. ...

Roof Console Replacement
Dome Lamp Bezel Roof Console Screw (Qty: 2) Caution: Refer to Fastener Caution in the Preface section. Tighten 2.5 N·m (22 lb in) Roof Console Assembly Procedure Disconnect  the electrical connectors. When replacing the driver information display bezel, remove the dri ...

Installation Procedure
Cut the rocker outer panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create 50 mm (2 in) backing plates from the unused portion of the ...

© 2011-2026 Copyright www.ccruze.com