Chevrolet Cruze Owners Manual: Service

Chevrolet Cruze Owners Manual / Climate Controls / Maintenance / Service

This vehicle may have the new environmentally friendly refrigerant, R1234yf. This refrigerant has a significantly reduced global warming impact on the environment, compared to the traditional automotive refrigerant, R-134a. All vehicles have a label underhood that identifies the refrigerant used in the vehicle.

The refrigerant system should only be serviced by trained and certified technicians. The air conditioning evaporator should never be repaired or replaced by one from a salvage vehicle. It should only be replaced by a new evaporator to ensure proper and safe operation.

During service, all refrigerants should be reclaimed with proper equipment. Venting refrigerants directly to the atmosphere is harmful to the environment and may also create unsafe conditions based on inhalation, combustion, frostbite, or other health-based concerns.

Passenger Compartment Air Filter

The filter removes dust, pollen, and other airborne irritants from outside air that is pulled into the vehicle. The filter should be replaced as part of routine scheduled maintenance. ...

Driving and Operating

...

Other materials:

Rear Side Door Window Adjustment
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Warning: Refer to Express Window Down Warning in the Preface section. Preliminary Procedures Remove the rear side door trim. Refer to Rear Side Door Trim Replacement. Remove the water deflector. ...

Reduced Engine Power Light
The reduced engine power light should come on briefly as the engine is started. If it does not come on, have the vehicle serviced by your dealer. This light, along with the malfunction indicator lamp, displays when a noticeable reduction in the vehicle's performance occurs. Stop the vehic ...

Installation Procedure
Prepare all mating surfaces as necessary. Align the front hinge pillar body reinforcement. Create 6 x 20 mm (4/16 x 12/16 in) slots for MIG-brazing in locations where you can not apply a resistance spot welder. Clean and prepare the attaching surfaces for spot welding a ...