Interior Windnoise
Squeaks and RattlesRemoval Procedure
Support the radiator and condenser from above using the
condenser tabs on each side.
Remove the lower steering intermediate shaft bolt (1).
Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assemblies. Refer to Tire and Wheel Remov ...
Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the tail lamp
pocket as noted from the original panel.
Note:
Clean and prepare the attaching surfaces for welding.
Position the tail lamp pocket on the vehicle.
Verify the fit of the tail lamp pocket.
Clamp ...
Installation Procedure
Align the front side door outer panel.
Verify the fit of the front side door outer panel.
Clamp the front side door outer panel
into position.
Pre-flanging the flange with BO-6396 pliers and BO-6392 tool kit .
Continue to hammer in stages along the hem flanges.
...