Chevrolet Cruze Owners Manual: Tire Messages
SERVICE TIRE MONITOR SYSTEM
This message displays if there is a problem with the Tire Pressure Monitor System (TPMS).
TIRE LEARNING ACTIVE
This message displays when the system is learning new tires.
TIRE PRESSURE LOW ADD AIR TO TIRE
On vehicles with the Tire Pressure Monitor System (TPMS), this message displays when the pressure in one or more of the vehicle's tires is low.
There is also an icon with the warning that will indicate the location of the low tire.
The low tire pressure warning light will also come on.
If a tire pressure message appears on the DIC, stop as soon as you can. Inflate the tires by adding air until the tire pressure is equal to the values shown on the Tire and Loading Information label.
You can receive more than one tire pressure message at a time. To read the other messages that may have been sent at the same time, press the SET/CLR button. The DIC also shows the tire pressure values.
Starting the Vehicle Messages
TURN STEERING WHEEL START VEHICLE AGAIN
This message displays when you try to start the vehicle, but the column remains
locked. Try turning the steering wheel while starting the vehicle to unlock t ...
Transmission Messages
SERVICE TRANSMISSION
This message displays if there is a problem with the transmission. See your dealer.
TRANSMISSION HOT — IDLE ENGINE
This message displays and a chime sounds if the transmission ...
Other materials:
Installation Procedure
Position the front end upper tie bar (1) on the vehicle.
Verify the fit of the front end upper tie bar.
Clamp the front end upper tie bar into position.
Weld seam accordingly.
Weld seam accordingly.
Grind down weld seams as needed for related panels and components.
...
Exit Lighting
The headlamps, taillamps, parking lamps, back-up lamps, and license plate lamps
come on at night, or in areas with limited lighting, when the key is removed from
the ignition.
The dome lamps also come on when the key is removed from the ignition. The exterior
lights and dome lamps remain on a ...
Front Fog Lamp Replacement
Preliminary Procedures
Raise and support the vehicle. Refer to Lifting
and Jacking the Vehicle.
Remove the front bumper fascia. Refer to Front Bumper Fascia
Replacement.
Disconnect fog lamp bulb socket electrical connector.
Front Fog Lamp Screws (Qty: 3)
Caution: Refer t ...
