This vehicle may come with a spare tire and tire changing equipment or a tire sealant and compressor kit.
The kit can be used to temporarily seal small punctures in the tread area of the tire.
Tire Pressure Monitor
Engine Oil Life SystemInstallation Procedure
Align the rocker inner panel.
Drill 8 mm (5/16 in) for plug welding along the edges of the quarter
outer panel as noted from the original panel.
Clean and prepare the attaching surfaces for welding.
Position the rocker inner panel on the vehicle.
Verify the fit of ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Dis ...
Installation Procedure
Remove rear end upper panel extension (1) from service part.
Cut
Cut the body side inner panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed to
allow a gap of one-and-one-half-times the metal thickness at the sectioni ...