Chevrolet Cruze Owners Manual: Engine Oil Life System
The engine oil life system calculates engine oil life based on vehicle use and displays the CHANGE ENGINE OIL SOON DIC message or Code 82 DIC message when it is necessary to change the engine oil and filter.
Remember, the Oil Life display must be reset after each oil change. It will not reset itself. Also, be careful not to reset the Oil Life display accidentally at any time other than when the oil has just been changed.
It cannot be reset accurately until the next oil change. To reset the engine oil life system press the SET button while the Oil Life display is active.
Resetting the Oil Life System
1. Using the DIC MENU button and thumbwheel, scroll until you reach REMAINING
OIL LIFE on the DIC (
% for Canada).
2. Press the SET button to reset the oil life at 100%. When prompted, use the thumbwheel to highlight YES or NO. Press the SET/CLEAR button to confirm.
Be careful not to reset the oil life display accidentally at any time other than after the oil is changed.
It cannot be reset accurately.
Tire Sealant and Compressor Kit
This vehicle may come with a spare tire and tire changing equipment or a tire
sealant and compressor kit.
The kit can be used to temporarily seal small punctures in the tread area of
the tire. ...
Driving for Better Fuel Economy
Driving habits can affect fuel mileage. Here are some driving tips to get the
best fuel economy possible.
• Avoid fast starts and accelerate smoothly.
• Brake gradually and avoid abrup ...
Other materials:
Rear Side Door Adjustment
Rear Side Door
Caution: Refer to Fastener Caution in the Preface section.
Procedure
Loosen the rear door hinge bolt (Qty: 4) to adjust the rear door.
Adjust the rear door in order to obtain an even gap between the rear
door and the roof, the quarter outer panel, the
rocker pan ...
Rear Compartment Lid Weatherstrip Replacement
Rear Compartment Lid Weatherstrip
Procedure
Start at the upper corner of the rear compartment opening and pull the
weatherstrip away from the rear
compartment opening flange.
Position the weatherstrip in the upper corner of the r 2. ear
compartment opening.
Working downward alon ...
Installation Procedure
Note: If the location of the original plug weld holes can not be
determined, space the plug weld holes every 40 mm (1½ in).
Drill 8 mm (5/16 in) for plug welding along the edges of the body rear
end panel as noted from the original panel.
Clean and prepare the attaching s ...
