Chevrolet Cruze Repair Manual: Windshield Washer Pump Replacement
Removal Procedure
- Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement.
- Disconnect the washer pump electrical connector (1).
- Disconnect the washer pump hose (2) from the washer pump (3).
- Using a small flat-bladed tool, remove the washer pump from the washer solvent container (5).
- Drain the windshield washer solvent into a clean suitable container.
- Using a small flat-bladed tool, remove the washer pump terminal seal (4) from the washer solvent container (1).
Installation Procedure
- Position the washer pump terminal seal (4) to the washer solvent container (5), pressing in until fully seated.
- Using full strength windshield washer solvent as a lubricant on the terminal seal, position the washer pump (3) to the washer solvent container (5) pressing in until fully seated.
- Connect the washer pump electrical connector (1).
- Connect the washer pump hose (2) to the washer pump (5).
- Install the front wheelhouse panel splash shield. Refer to Front Wheelhouse Liner Replacement.
- Fill the washer solvent container with washer solvent.
- Inspect the washer system for proper operation.
Windshield Washer Nozzle Hose Replacement
Preliminary Procedure
Remove the hood insulator. Refer to
Hood Insulator Replacement.
Place a clean container under the front driver side near where the
windshield washer nozzle ...
Windshield Washer Pump Seal Replacement
Removal Procedure
Open the hood.
Remove the windshield washer pump. Refer to Windshield Washer Pump
Replacement
Using a small flat-bladed tool, remove the washer pump terminal seal (1) ...
Other materials:
Fuel Additives
To provide cleaner air, all gasolines in the United States are now required to
contain additives that help prevent engine and fuel system deposits from forming,
allowing the emission control system to work properly. In most cases, nothing should
have to be added to the fuel.
However, some gas ...
Engine Oil Life System
When to Change Engine Oil
This vehicle has a computer system that indicates when to change the engine oil and filter. This is based on a combination of factors which include engine revolutions, engine temperature, and miles driven.
Based on driving conditions, the mileage at which an oil ...
Installation Procedure
Clean and prepare the attaching surfaces for brazing.
Apply structural adhesive to the attaching surfaces.
Position the rear bumper impact bar stud plate on the vehicle.
Verify the fit of the rear bumper impact bar stud plate
Clamp the rear bumper impact bar stud plate into ...
