Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Hood Adjustment

Hood

Hood

Caution: Refer to Fastener Caution in the Preface section.

Procedure

  1. Loosen the hood hinge reinforcement nuts (Qty: 4).
  2. Adjust the hood in order to obtain an even gap on both sides between the hood and the fenders, the headlamps and the front bumper fascia and so that the hood is flush with both fenders on the front edge, the front bumper fascia and the headlamps.

Adjustment

Tighten 26 N·m (20 lb ft)

Rear Side Door Upper Hinge and Lower Hinge Replacement
Preliminary Procedure Remove the rear side door. Refer to Rear Side Door Replacement. Rear Side Door Hinge Bolt (Qty: 4) Caution: Refer to Fastener Caution in the Preface section. Tight ...

Hood Replacement
Warning: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury. Preliminary Procedure Remo ...

Other materials:

Front Suspension Description and Operation
The front suspension has 2 primary purposes: Isolate the driver from irregularities in the road surface. Define the ride and handling characteristics of the vehicle. The front suspension absorbs the impact of the tires travelling over irregular road surfaces and dissipates this energy thr ...

Rear Wheel Bearing and Hub Replacement (Drum Brake)
Special Tools EN 45059 Torque Angle Sensor Kit For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and suitably support the vehicle. Refer to Lifting   and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and ...

Front Bumper Impact Bar Replacement
Removal Procedure Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Disabling and Enabling. Disconnect the negative battery ...

© 2011-2026 Copyright www.ccruze.com