Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Turn Signal Switch Replacement

Preliminary Procedure

Preliminary Procedure

  1. Remove the steering column upper trim cover. Refer to Steering Column Upper Trim  Cover Replacement.
  2. Remove the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement.

Turn Signal Switch

Procedure

  1. Disconnect any electrical connectors as needed.
  2. Release the plastic retaining tabs to release the turn signal switch from steering wheel inflatable restraint module coil.

Steering Wheel Replacement

Prelimary Procedure

Prelimary Procedure

Remove the inflatable restraint steering wheel module. Refer to Steering Wheel Inflatable Restraint Module Replacement.

Steering Wheel Bolt

Caution: Refer to Fastener Caution in the Preface section.

Procedure

  1. Clean thread of the bolt.
  2. Apply locking compound to the thread. Refer to Adhesives, Fluids, Lubricants, and Sealers

Tighten 30 N·m (23 lb ft)

Steering Wheel

Procedure

  1. Disconnect electrical connectors as needed.
  2. Remove the steering wheel carefully.
Intermediate Steering Shaft Replacement
Removal Procedure Turn the steering wheel to the straight forward position and support it from movement Remove the 2 intermediate steering shaft bolts (1). Remove the interm ...

Steering Column Replacement (Right Hand Drive)
Caution: With wheels of the vehicle facing straight ahead, secure the steering wheel utilizing steering column anti-rotation pin, steering column lock, or a strap to prevent rotation. Locking of th ...

Other materials:

Paint Gauges
Paint thickness gauge. measure the total thickness of the vehicle finish. It is important to accurately measure the thickness of the finish on each vehicle as the thickness of the finish will vary on each vehicle. Use a paint gauge before the sanding process in order to accurately measure how ...

Safety Belt Extender
If the vehicle's safety belt will fasten around you, you should use it. But if a safety belt is not long enough, your dealer will order you an extender. When you go in to order it, take the heaviest coat you will wear, so the extender will be long enough for you. To help avoid personal inju ...

Headlamp High/Low-Beam Changer
(Headlamp High/Low-Beam Changer): Push the turn signal lever away from you and release to turn the high beams on. To return to low beams, push the lever again or pull it toward you and release. This indicator light turns on in the instrument cluster when the high-beam headlamps are on. ...

© 2011-2026 Copyright www.ccruze.com