Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Body Side Outer Lower Panel Replacement (MAG-Welding)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Body Side Outer Lower Panel Replacement (MAG-Welding)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Remove rear end upper panel extension (1) from service part. Cut the body side inner panel in corresponding locations to fit the remaining original panel. The sectioning joint shou ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR Syst ...

Other materials:

Fuel and Evaporative Emission Pipe Warning
Warning: In order to reduce the risk of fire and personal injury observe the following items: Replace all nylon fuel pipes that are nicked, scratched or damaged during installation, do not attempt to repair the sections of the nylon fuel pipes Do not hammer directly on the fuel harness ...

Climate Controls
The heating, cooling, defrosting, and ventilation for the vehicle can be controlled with these systems. Vehicles without Air Conditioning 1. Temperature Control 2. Bi-level Air Mode 3. Floor Air Mode 4. Vent Air Mode 5. Fan Control 6. Driver and Passenger Heated Seats (If Equipped) 7. Re ...

Front Side Door Replacement
Preliminary Procedure Remove the front side door trim panel. Refer to Front Side Door Trim Replacement. Front Side Door Check Link Bolt Caution: Refer to Fastener Caution in the Preface section. Procedure Remove the water deflector. Disconnect the door electrical connector. Su ...

© 2011-2026 Copyright www.ccruze.com