Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.
Installation Procedure
Removal ProcedureRemoval Procedure
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface
section.
Disable the SIR System. Refer to SIR Disabling
and Enabling.
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove the front side door. Refer t ...
Scrapping Procedure
During the course of a vehicle's useful life, certain situations may arise
which will necessitate the disposal of a live (undeployed)
pretensioner. The following information covers the proper procedures for the
disposing of a live (undeployed) pretensioner. Deploy the
pretensioner before dispo ...
Installation Procedure
Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along the edges
of the tail lamp pocket as noted f rom the
original panel.
Note:
Clean and prepare the attaching surfaces for brazing.
Position the tail lamp pocket on the vehicle.
Verify the fit of the ta ...