Special Tools
For equivalent regional tools, refer to Special Tools.
Stabilizer Shaft Link Replacement
Removal ProcedureTyre and Wheel Removal and Installation
Removal Procedure
Raise and suitably support the vehicle. Refer to Lifting and Jacking the
Vehicle.
Remove the wheel center cap.
Mark the relationship of the wheel (2) to the hub.
Remove the wheel nuts (1).
Warning: If penetrating oil gets on the vertical surfaces between the ...
Headlamp Aiming Procedure
Open the hood.
Measure from the floor to the center of the headlamp bulb. Some
headlamps have an aim dot marked on the headlamp lens.
At the screen, measure from the floor and place the horizontal tape at
the measured distance.
Measure from the reference line on the floor to the le ...
High Strength Low Alloy Steel
This information provides repair recommendations and general guidelines for
steel classified as High Strength Low Alloy Steel, also known
as HSLA. This type of steel normally has a tensile strength range from 300-700
MPa.
General Motors recommends the following when repairing or replacing th ...