Chevrolet Cruze Repair Manual: Body Side Outer Panel Reinforcement Replacement (MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.
Installation Procedure
Cut the rocker outer panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed to
allow a gap of one-and-one-half-times the metal thickne ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
Warning: Refer to Glass and She ...
Other materials:
Seat Belt Latch Stop Installation
Preliminary Procedure
Locate the hole in the seat belt webbing where the original seat belt
stop button was located.
If the original hole in the seat belt webbing is not visible, perform
the following:
If either the right or left stop button is missing use the opposing seat
...
Customer Assistance Offices
Chevrolet encourages customers to call the toll-free number for assistance. However,
if a customer wishes to write or e-mail Chevrolet, the letter should be addressed
to:
United States and Puerto Rico
Chevrolet Motor Division
Chevrolet Customer Assistance Center
P.O. Box 33170
Detroit, MI 4 ...
Front Wheel Drive Shaft Replacement - Left Side
Special Tools
CH-313 Slide Hammer
CH-6003 Axle Shaft Remover
CH-46376 Holding Wrench
CH-49400 Hub Spindle Remover
DT-6332 Seal Protector
EN-956-1 Extension
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Warning: To prevent personal injury and/or component ...
