For any bulb-changing procedure not listed in this section, contact your dealer.
Headlamp Aiming
Halogen HeadlampsInstallation Procedure
Position the front brake shield (2) and front wheel bearing/hub (1)
assembly in the steering knuckle.
Caution: Refer to Fastener Caution in the Preface section.
Install the NEW front wheel bearing/hub bolts (1).
Tighten the bearing/hub bolts (1) in 3 passes. Use the EN-45059 k ...
Radio Frequency Statement
This vehicle has systems that operate on a radio frequency that comply with Part
15 of the Federal Communications Commission (FCC) rules and with Industry Canada
Standards RSS-GEN/210/220/310.
Operation is subject to the following two conditions:
1. The device may not cause harmful interferenc ...
Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the drivetrain
and front suspension frame front support as noted from the
original panel.
Clean and prepare the attaching surfaces for welding.
Position the drivetrain and front suspension frame front suppor ...