To flash the high beams, pull the turn signal lever all the way toward you. Then release it.
Headlamp High/Low-Beam Changer
Daytime Running Lamps (DRL)Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Disabling
and Enabling.
Disconnect the negative battery cable. Refer to ...
Paint Gauges
Paint thickness gauge. measure the total thickness of the vehicle finish. It
is important to accurately measure the thickness of the finish on
each vehicle as the thickness of the finish will vary on each vehicle. Use a
paint gauge before the sanding process in order to accurately
measure how ...
Installation Procedure
Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing
(1).
Clean and prepare the attaching surfaces for spot welding and brazing.
Note: In MIG-brazing areas 50 mm (2 in) must be kept clear
of structural adhesive.
Apply structural adhesive to all attaching surfaces ...