Head Restraints
Seat AdjustmentInstallation Procedure
Note: If the location of the original plug weld holes can not be
determined, space the plug weld holes every 40 mm (1½ in).
Drill 8 mm (5/16 in) for plug welding along the edges of the rear floor
panel filler as noted from the original
panel.
Clean and prepare the atta ...
Stationary Window Waterleak Repair
Note: If any water enters the vehicle interior up to the level of
the carpet or higher and soaks the carpet, the sensing and diagnostic
module (SDM) and the SDM harness connector may need to be replaced. The SDM
could be activated when powered, which could
cause deployment of the air bag(s) an ...
Hood
To open the hood:
1. Pull up on the hood release handle. It is located inside the vehicle to the
left of the steering column.
2. Go to the front of the vehicle and push the secondary hood release handle
toward the driver side of the vehicle.
3. Lift the hood and release the hood prop fr ...