Chevrolet Cruze Repair Manual: Instrument Panel Accessory Bezel Replacement
Preliminary Procedure
Remove transmission control cover. Refer to Automatic or Manual Transmission Control Lever Trim Cover Replacement.
- Instrument Panel Accessory Bezel Screw (Qty: 4)
Caution: Refer to Fastener Caution in the Preface section.
Tighten 2.5 N·m (23 lb in).
- Instrument Panel Accessory Bezel Assembly
Driver Information Display Bezel Replacement
Preliminary Procedure
Remove the radio control module. Refer to Radio Control Module Replacement
- Driver Information Display Bezel Screw (Qty: 2)
Caution: Refer to Fastener Caution in the Preface section.
Tighten 2.5 N·m (23 lb in)
- Driver Information Display Bezel Assembly
Tip: When replacing the driver information display bezel, remove the driver information display.
Instrument Panel Cluster Trim Plate Replacement
- Instrument Panel Cluster Trim Plate Assembly.
Instrument Panel Outer Trim Cover Replacement - Right Side
- Instrument Panel Outer Trim Cover - Right Side.
Instrument Panel Outer Trim Cover Replacement - Left Side
- Instrument Panel Outer Trim Cover - Left Side.
Instrument Panel and Console Trim
Specifications
Instrument Panel Insulator Seal Replacement
Preliminary Procedure
Remove the instrument panel assembly. Refer to Instrument Panel Assembly
Replacement.
Instrument P ...
Instrument Panel Lower Trim Pad Cover Replacement
Preliminary Procedure
Remove the left outer trim cover. Refer to Instrument Panel Outer Trim Cover
Replacement - Left Side.
Instrument Panel Lower Trim Pad Cover Screw (Qty: 3)
Caution: ...
Other materials:
Rear Bumper Fascia Replacement
Preliminary Procedure
Remove the tail lamps. Refer to Tail Lamp Replacement.
Rear Bumper Fascia Retainer (Qty: 2)
Rear Wheelhouse Liner Bolt (Qty: 6)
Caution: Refer to Fastener Caution in the Preface section.
Tighten
2.5 N·m (23 lb in)
Rear Bumper Fascia
Procedure
Pull th ...
Exhaust Flexible Pipe Replacement (1.6L LXT)
Removal Procedure
Warning: Refer to Hot Exhaust System Warning in the Preface section.
Warning: Refer to Protective Goggles and Glove Warning in the Preface section.
Open the hood.
Raise the vehicle by its full height. Refer to Lifting and Jacking the
Vehicle.
Remove the heate ...
Installation Procedure
Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-Brazing along the edges
of the front wheelhouse front panel as noted from the
original panel.
Create a 5 x 18 mm (4/16 x 11/16 in) slot for MIG-Brazing where front
wheelhouse front panel and front wheelhouse overlap.
C ...
