Chevrolet Cruze Repair Manual: Rear Seat Back Cushion Cover and Pad Replacement - Left Side
Preliminary Procedure
Remove rear seat - left side. Refer to Rear Seat Replacement
Rear Seat Back Cushion Cover
Procedure
- Remove the staples from the seat back cover.
- Remove seat back cushion cover from Velcro.
Rear Seat Back Cushion Pad
Rear Seat Back Cushion Cover and Pad Replacement - Right Side
Preliminary Procedure
- Remove rear seat back - right side. Refer to Rear Seat Replacement.
- Remove rear seat armrest. Refer to Rear Seat Armrest Replacement.
Rear Seat Back Cushion Cover
Procedure
- Remove the staples from the seat back cover.
- Remove seat back cushion cover from Velcro.
Rear Seat Back Cushion Pad
Passenger Seat Frame Replacement
Removal Procedure
Remove front seat cushion cover (1) and pad (2) from frame (3). Refer to
Front Seat Cushion Cover and Pad Replacement
Remove the wire harness (1), if equip ...
Thread Repair
General purpose thread repair kits are available commercially.
Warning: Refer to Safety Glasses Warning in the Preface section.
Note: Refer to the thread repair kit manufacturer's instructions
...
Other materials:
Instrument Panel Outer Air Outlet Duct Replacement
Preliminary Procedure
Remove instrument panel assembly. Refer to Instrument Panel Assembly
Replacement.
Instrument Panel Outer Air Outlet Duct Screw (Qty: 7)
Caution: Refer to Fastener Caution in the Preface section.
Tighten
2.5 N·m (22 lb in)
Instrument Panel Outer Air Outlet Duct
Floo ...
Inflatable Restraint Module Handling and Scrapping
Special Tools
EL-38826 SIR Deployment Harness
EL-39401-B SIR Deployment Fixture
For equivalent regional tools, refer to Special Tools.
Live and Undeployed Inflator Module
Warning: Refer to SIR Inflator Module Handling and Storage Warning
in the Preface section.
Take special care when h ...
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the
Vehicle.
Remove the tire and wheel. Refer to Tire and Wheel Removal and
Installation.
Note: DO NOT re-use the lower control arm bolts and nuts. Discard
and use NEW only.
Remove wheel speed sensor wiring harness ...
