SERVICE TRACTION CONTROL
This message displays when there is a problem with the Traction Control System (TCS).
SERVICE STABILITRAK
This message displays if there is a problem with the StabiliTrak system.
Object Detection System Messages
Airbag System MessagesFog Lamp Aiming
Preparation Procedure
Important: Horizontal aim is not adjustable on this vehicle.
Vertical aim is done by an adjusting nut located on the rear of the fog lamp.
Prior to aiming the fog lamps, perform the following steps:
Completely assemble all of the components on the vehicle.
Place the ...
Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the rear bumper
impact bar stud plate as noted from the original panel.
Note: If the location of the original plug weld holes can
not be determined, space the plug weld holes every 40 mm (1½ in).
Clean and prepare the ...
Installation Procedure
Remove the front wheelhouse rear panel brace (1) from service panel.
Drill 8 mm (5/16 in) for plug welding instead of the adhesive noted from
the front area of the original panel.
Note: Double the number of drills at the flange where front
wheelhouse panel and front comp ...