Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Object Detection System Messages

PARK ASSIST OFF

This message displays when the park assist system has been turned off or when there is a temporary condition causing the system to be disabled.

SERVICE PARK ASSIST

This message displays if there is a problem with the Ultrasonic Rear Parking Assist (URPA) system. Do not use this system to help you park.

SERVICE SIDE DETECTION SYSTEM

If this message appears, the system needs service. Take the vehicle to your dealer.

SIDE BLIND ZONE ALERT OFF

This message indicates that the driver has turned the system off.

SIDE DETECTION SYSTEM UNAVAILABLE

This message indicates that the SBZA system is disabled because the sensor is blocked and cannot detect vehicles in the blind zone.

The sensor may be blocked by mud, dirt, snow, ice, or slush. This message may also activate during heavy rain or due to road spray. The vehicle does not need service.

Lamp Messages
AUTOMATIC LIGHT CONTROL ON This message is displayed when the automatic light control has been turned on. AUTOMATIC LIGHT CONTROL OFF This message is displayed when the automatic light control has ...

Ride Control System Messages
SERVICE TRACTION CONTROL This message displays when there is a problem with the Traction Control System (TCS). SERVICE STABILITRAK This message displays if there is a problem with the StabiliTrak ...

Other materials:

Vehicle, Engine and Transmission ID and VIN Location, Derivative and Usage
Note:: Graphic shows exemplary VIN. The VIN plate is the legal identifier of the vehicle. The VIN plate is located on the upper left corner of the instrument panel (I/P) and can be seen through the windshield from the outside of the vehicle: ...

Instrument Panel Fuse Block
The instrument panel fuse block is in the driver side of the instrument panel. To access the fuses: 1. Open the fuse block cover by pulling out at the top. 2. Remove the lower edge of the cover. 3. Remove the cover. To reinstall the cover, reverse the steps above. Instrument Panel Fuse Bl ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the tail lamp pocket as noted  from the original panel. Note: Clean and prepare the attaching surfaces for welding. Position the tail lamp pocket on the vehicle. Verify the fit of the tail lamp pocket. Clamp ...

© 2011-2026 Copyright www.ccruze.com