The rear door safety locks prevent passengers from opening the rear doors from inside the vehicle.

Press
to activate the safety locks.
The indicator light comes on when activated.
The rear door power windows are also disabled.
Press
again to deactivate the safety
locks and power windows.
If the indicator light flashes, the feature may not be working properly.
If a rear door handle is pulled when the safety lock is deactivated, that door will remain locked and the indicator light may flash. Release the handle, then press the safety lock twice to deactivate the safety locks.
Automatic Door Locks
DoorsUltra High Strength Dual Phase Steel
This information provides repair recommendations and general guidelines for
steel classified as Ultra High Strength Dual Phase Steel (Dual
Phase Steel with a tensile strength greater than 800 MPa), also known as DPX.
General Motors recommends the following when repairing or replacing this type ...
Headlamp Mount Panel Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface sec ...
Daytime Running Lamps (DRL)
Daytime Running Lamps can make it easier for others to see the front of your
vehicle during the day. Fully functional daytime running lamps are required on all
vehicles first sold in Canada.
A light sensor on top of the instrument panel makes the DRL work, so be sure
it is not covered.
The D ...