Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Body Hinge Pillar Lower Reinforcement Replacement (MIG-Brazing)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Body Hinge Pillar Lower Reinforcement Replacement (MIG-Brazing)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Prepare all mating surfaces as necessary. Align the front hinge pillar body reinforcement. Drill 8 mm (5/16 in) for plug welding along the edges of the front hinge pillar body as not ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and She ...

Other materials:

Thread Repair
General purpose thread repair kits are available commercially. Warning: Refer to Safety Glasses Warning in the Preface section. Note: Refer to the thread repair kit manufacturer's instructions regarding the size of the drill and which tap to use. Always avoid any buildup of chips. Back ou ...

Rear Side Door Check Replacement
Preliminary Procedure Remove rear side door trim panel. Refer to Rear   Side Door Trim Replacement Remove the rear side door water deflector. Refer to Rear Side Door Water Deflector Replacement Rear Side Door Check Bolt Caution: Refer to Fastener Caution in the Pre ...

High Strength Low Alloy Steel
This information provides repair recommendations and general guidelines for steel classified as High Strength Low Alloy Steel, also known as HSLA. This type of steel normally has a tensile strength range from 300-700 MPa. General Motors recommends the following when repairing or replacing th ...

© 2011-2026 Copyright www.ccruze.com