Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Body Side Inner Panel Sectioning (MIG-Brazing)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Body Side Inner Panel Sectioning (MIG-Brazing)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Remove rear end upper panel extension (1) from service part. Cut Cut the body side inner panel in corresponding locations to fit the remaining original panel. The sectioning jo ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and She ...

Other materials:

Scrapping Procedure
During the course of a vehicle's useful life, certain situations may arise which will necessitate the disposal of a live (undeployed) pretensioner. The following information covers the proper procedures for the disposing of a live (undeployed) pretensioner. Deploy the pretensioner before dispo ...

Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located in the trunk, under the load floor, behind an access panel. To remove the kit: 1. Open the trunk. 2. Turn the left knob counterclockwise and the right knob clockwise, 90 degrees, at the same time. Then pull the access panel rearward and up to r ...

Removal Procedure
Turn the front wheels to the straight forward position and secure the steering  wheel from moving. Remove the 2 lower steering intermediate shaft bolts (1). Remove the steering intermediate shaft from the steering gear. Raise and support the vehicle. Refer to Lifting and Jac ...

© 2011-2026 Copyright www.ccruze.com