Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Rail Sectioning (MIG-Brazing)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Rear Rail Sectioning (MIG-Brazing)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Cut the rear side rail in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness a ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and She ...

Other materials:

Steering Gear Boot Replacement
Special Tools CH-804 Drive Axle Seal Clamp Pliers Removal Procedure Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement. Remove the steering linkage inner tie rod nut (1). Remove the steering gear outer boot clamp (2). Loosen the st ...

Steering Linkage Inner Tie Rod Replacement (Hydraulic Power Steering)
Special Tools CH-6247 Removal and Installation Tool for the Steering Linkage Inner Tie Rod For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and support the vehicle. Refer to Lifting  and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to ...

Removal Procedure
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Disabling and Enabling. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the front side door. Refer t ...

© 2011-2026 Copyright www.ccruze.com