Chevrolet Cruze Repair Manual: Seat Hardware, Trim, and Upholstery
Specifications
- Driver or Passenger Seat Replacement
- Front Seat Track Synchronization
- Front Seat Cushion Cover and Pad Replacement
- Driver or Passenger Seat Back Cushion Cover and Pad Replacement
- Driver or Passenger Seat Recliner Handle Replacement
- Driver Seat Frame Replacement
- Passenger Seat Frame Replacement
- Rear Seat Back Cushion Cover and Pad Replacement - Left Side
- Thread Repair
Seats
...
Driver or Passenger Seat Replacement
Removal Procedure
Warning: Refer to SIR Warning in the Preface section.
Warning: When carrying a live inflator module, make sure the bag
opening is pointed away from you. This minimizes the ch ...
Other materials:
Installation Procedure
Clean and prepare the attaching surfaces for brazing.
Apply structural adhesive to the attaching surfaces.
Position the rear bumper impact bar stud plate on the vehicle.
Verify the fit of the rear bumper impact bar stud plate
Clamp the rear bumper impact bar stud plate into ...
Installation Procedure
Cut the roof front header panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed
to allow a gap of one-and-one-half-times the metal thickness at the
sectioning joint.
Create a 50 mm (2 in) backing plate from the unused portion of ...
Rear Side Door Adjustment
Rear Side Door
Caution: Refer to Fastener Caution in the Preface section.
Procedure
Loosen the rear door hinge bolt (Qty: 4) to adjust the rear door.
Adjust the rear door in order to obtain an even gap between the rear
door and the roof, the quarter outer panel, the
rocker pan ...
