Chevrolet Cruze Repair Manual: Drivetrain and Front Suspension Frame Replacement

Frame and Underbody

Specifications Engine Shield Replacement Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Engine Shield Bolt (Qty: 4) Caution: Refer to ...

Removal Procedure

Support the radiator and condenser from above using the  condenser tabs on each side. Remove the lower steering intermediate shaft bolt (1). Raise the vehicle on a hoist. Refer to Li ...

Other materials:

Rear Compartment Lid Emblem/Nameplate Replacement (Rear Emblem)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to deve ...

Infotainment
The names, logos, emblems, slogans, vehicle model names, and vehicle body designs appearing in this manual including, but not limited to, GM, the GM logo, CHEVROLET, the CHEVROLET Emblem, CRUZE, and the CRUZE logo are trademarks and/or service marks of General Motors LLC, its subsidiaries, a ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the body side outer lower panel as noted from the original panel. Note: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1½ in). Clean and prepare the attac ...