Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Front End Upper Tie Bar Replacement (MIG-Brazing)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Front End Upper Tie Bar Replacement (MIG-Brazing)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Position the front end upper tie bar (1) on the vehicle. Verify the fit of the front end upper tie bar. Clamp the front end upper tie bar into position. Weld seam accordingly. ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. ...

Other materials:

Rear Side Door Window Adjustment
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Warning: Refer to Express Window Down Warning in the Preface section. Preliminary Procedures Remove the rear side door trim. Refer to Rear Side  Door Trim Replacement. Remove the water deflector. ...

Installation Procedure
Remove rear end upper panel extension (1) from service part. Cut Cut the body side inner panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioni ...

Parking Brake
To apply the parking brake, pull up on the parking brake handle. It is not necessary to push in on the release button while applying the parking brake. If the ignition is in the ON/RUN position, the brake system warning light will come on. To release the parking brake: 1. Hold the brake peda ...

© 2011-2026 Copyright www.ccruze.com