While parked, and with the parking brake set, try to turn the ignition to LOCK/OFF in each shift lever position.
• For automatic transmission vehicles, the ignition should turn to LOCK/OFF only when the shift lever is in P (Park). The ignition key should come out only in LOCK/OFF.
• For manual transmission vehicles, the ignition key should come out only in LOCK/OFF.
Contact your dealer if service is required.
Automatic Transmission Shift Lock Control Function Check
Park Brake and P (Park) Mechanism CheckInstallation Procedure
Remove rear end upper panel extension (1) from service part.
Cut
Cut the body side inner panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed to
allow a gap of one-and-one-half-times the metal thickness at the sectioni ...
High Strength Low Alloy Steel
This information provides repair recommendations and general guidelines for
steel classified as High Strength Low Alloy Steel, also known
as HSLA. This type of steel normally has a tensile strength range from 300-700
MPa.
General Motors recommends the following when repairing or replacing th ...
Wiper Blade Replacement
Windshield wiper blades should be inspected for wear and cracking.
Replacement blades come in different types and are removed in different ways.
Notice: Allowing the wiper arm to touch the windshield when no wiper
blade is installed could damage the windshield. Any damage that occurs would not
...