Chevrolet Cruze Owners Manual: Passenger Sensing System
United States
Canada
The passenger sensing system turns off the front outboard passenger frontal airbag and knee airbag under certain conditions. No other airbag is affected by the passenger sensing system.
The passenger airbag status indicator will be visible on the instrument panel when the vehicle is started.
Safety Belts
Refer to the following sections for important information on how to use safety
belts properly:
• Safety Belts
• How to Wear Safety Belts Properly
• Lap-Shoulder Belt
• Lower Anchors and Teth ...
Mirror Adjustment
Exterior
Controls for the outside power mirrors are on the driver door.
1. Turn the selector switch to L (Left) or R (Right) to choose the driver or
passenger mirror.
2. Move the control to adj ...
Other materials:
Seat Belt Latch Stop Installation
Preliminary Procedure
Locate the hole in the seat belt webbing where the original seat belt
stop button was located.
If the original hole in the seat belt webbing is not visible, perform
the following:
If either the right or left stop button is missing use the opposing seat
...
Side Blind Zone Alert (SBZA)
The vehicle may have a Side Blind Zone Alert (SBZA) system. Read this entire
section before using the system.
WARNING
SBZA does not detect vehicles rapidly approaching outside of the side blind
zones, pedestrians, bicyclists, or animals. Failure to use proper care when changing
lanes may res ...
Installation Procedure
Remove the front wheelhouse rear panel brace (1) from service panel.
Create 6 x 20 mm (4/16 x 12/16 in) slots for MIG-brazing along the edges
of the front wheelhouse (1).
Clean and prepare the attaching surfaces for brazing.
Note: In MIG-brazing areas 50 mm (2 in) must b ...
