Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Drivetrain and Front Suspension Frame Front Support Replacement (MAG-Welding)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Drivetrain and Front Suspension Frame Front Support Replacement (MAG-Welding)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Position the front end upper tie bar (1) on the vehicle. Verify the fit of the front end upper tie bar. Clamp the front end upper tie bar into position. Braze accordingly. ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR Syst ...

Other materials:

Installation Procedure
Position the front brake shield (2) and front wheel bearing/hub (1) assembly in the steering knuckle. Caution: Refer to Fastener Caution in the Preface section. Install the NEW front wheel bearing/hub bolts (1). Tighten the bearing/hub bolts (1) in 3 passes. Use the EN-45059 k ...

Basecoat/Clearcoat Paint Systems
Warning: Exposure to isocyanates during paint preparation and application processes can cause severe breathing problems. Read and follow all of the instructions from the manufacturers of painting materials, equipment, and protective gear. All paint finish repairs of rigid exterior surfaces mus ...

Installation Procedure
Note: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1½ in). Drill 8 mm (5/16 in) for plug welding along the edges of the rear floor panel filler as noted  from the original panel. Clean and prepare the atta ...

© 2011-2026 Copyright www.ccruze.com