Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Front Wheelhouse Panel Replacement (MIG-Brazing)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Front Wheelhouse Panel Replacement (MIG-Brazing)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Remove the front wheelhouse rear panel brace (1) from service panel. Drill 8 mm (5/16 in) for plug welding instead of the adhesive noted from the front area of the original panel. ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR Syst ...

Other materials:

Installation Procedure
Align the rocker inner panel. Clean and prepare the attaching surfaces for spot welding. Apply structural adhesive to all attaching surfaces. Position the rocker  inner panel on the vehicle. Verify the fit of the quarter outer panel Clamp the rocker inner panel into posi ...

Installation Procedure
Clean and prepare the attaching surfaces for brazing. Apply structural adhesive to the attaching surfaces. Position the rear bumper impact  bar stud plate on the vehicle. Verify the fit of the rear bumper impact bar stud plate Clamp the rear bumper impact bar stud plate into ...

Introduction
The names, logos, emblems, slogans, vehicle model names, and vehicle body designs appearing in this manual including, but not limited to, GM, the GM logo, CHEVROLET, the CHEVROLET Emblem, and CRUZE are trademarks and/or service marks of General Motors LLC, its subsidiaries, affiliates, or li ...

© 2011-2026 Copyright www.ccruze.com