Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Paint and Coatings

Installation Procedure
Install the following components on the drivetrain and front suspension frame: CH 49460-1 adapter (2). CH 49460-2 adapter (4). CH 6615-10 hydraulic cylinder (1). NEW frame insula ...

Basecoat/Clearcoat Paint Systems
Warning: Exposure to isocyanates during paint preparation and application processes can cause severe breathing problems. Read and follow all of the instructions from the manufacturers of painting m ...

Other materials:

Shock Absorber Disposal
Warning: Use the proper eye protection when drilling to prevent metal chips from causing physical injury. Clamp the strut in a vise horizontally with the rod ( 1) completely extended. Drill a hole in the strut at the center of the end cap (3) using a 5 mm (3/16 in) drill bit. Gas o ...

Rear Compartment Lid Emblem/Nameplate Replacement (Cruze - Right Side)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to deve ...

Safety Belt Extender
If the vehicle's safety belt will fasten around you, you should use it. But if a safety belt is not long enough, your dealer will order you an extender. When you go in to order it, take the heaviest coat you will wear, so the extender will be long enough for you. To help avoid personal inju ...

© 2011-2026 Copyright www.ccruze.com