Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Wheelhouse Panel Replacement (MAG-Welding)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Rear Wheelhouse Panel Replacement (MAG-Welding)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Align the rear compartment floor panel. Drill 4 mm (3/16 in) for rivets along the edges of the rear compartment floor were you cant apply a resistance spot welder. Clean and prepare ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. ...

Other materials:

Lamp Messages
AUTOMATIC LIGHT CONTROL ON This message is displayed when the automatic light control has been turned on. AUTOMATIC LIGHT CONTROL OFF This message is displayed when the automatic light control has been turned off. XXX TURN INDICATOR FAILURE When one of the turn signals is out, this message disp ...

Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the brake rotor. Refer to Front Brake Rotor Replacement. Remove the wheel speed sensor screw (2). Remove the wheel speed sensor (1) from the steering knuckle. Remove the wheel drive shaft from the fron ...

Cooling System
The cooling system allows the engine to maintain the correct working temperature. 1.4L L4 Engine Shown, 1.8L L4 Engine Similar 1. Engine Cooling Fan (Out of View) 2. Engine Coolant Surge Tank and Pressure Cap WARNING An electric engine cooling fan under the hood can start up even when the eng ...

© 2011-2026 Copyright www.ccruze.com