Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Tail Lamp Pocket Replacement (MAG-Welding)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Tail Lamp Pocket Replacement (MAG-Welding)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Note: If the location of the original plug weld holes can not be determined, space the braze holes every 40 mm (1½ in). Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR Syst ...

Other materials:

Removal Procedure
Support the radiator and condenser from above using the  condenser tabs on each side. Remove the lower steering intermediate shaft bolt (1). Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle. Remove the tire and wheel assemblies. Refer to Tire and Wheel Remov ...

Removal Procedure
Raise and support the vehicle. Refer to Lifting  and Jacking the Vehicle. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation. Note: DO NOT re-use the lower control arm bolts and nuts. Discard and use NEW only. Remove wheel speed sensor wiring harness ...

Rear Side Door Stationary Window Replacement
Preliminary Procedures Remove the rear side door trim panel. Refer to Rear  Side Door Trim Replacement. Remove the rear side water deflector. Refer to Rear Side Door Water Deflector Replacement. Remove the rear door window outer sealing strip. Refer to Rear Side Door Window ...

© 2011-2026 Copyright www.ccruze.com