Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Body Lock Pillar Outer Panel Sectioning (MAG-Welding)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Body Lock Pillar Outer Panel Sectioning (MAG-Welding)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Align the rocker inner panel. Clean and prepare the attaching surfaces for spot welding. Apply structural adhesive to all attaching surfaces. Position the rocker  inner panel on ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and She ...

Other materials:

Airbag Readiness Light
This light shows if there is an electrical problem with the airbag system. The system check includes the airbag sensor(s), passenger sensing system, the pretensioners, the airbag modules, the wiring, and the crash sensing and diagnostic module. The airbag readiness light comes on for several ...

Inflatable Restraint Side Impact Sensor Replacement
Warning: Refer to SIR Warning in the Preface section. Warning: Refer to SIR Inflator Module Handling and Storage Warning in the Preface section. Warning: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary: Th ...

Rear Compartment Lid Emblem/Nameplate Replacement (VCDi)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to deve ...

© 2011-2026 Copyright www.ccruze.com