Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Floor Coverings and Headlinings

Chevrolet Cruze Repair Manual / Body hardware and trim / Floor Coverings and Headlinings

Water Management Description and Operation
Plenum Water Flow Direction and Cleaning A large percentage of water will flow off the windshield area into the plenum chamber drain system and then down the outside on the plenum to the underside ...

Floor Carpet Drying
If the carpet or the pad or insulator is wet, use the following criteria for drying or for replacing the components: For a 1-piece carpet assembly bonded to a cotton or a fiber padding, repla ...

Other materials:

Floor Mats
WARNING If a floor mat is the wrong size or is not properly installed, it can interfere with the pedals. Interference with the pedals can cause unintended acceleration and/or increased stopping distance which can cause a crash and injury. Make sure the floor mat does not interfere with the p ...

Rear Axle Replacement
Special Tools EN 45059 Torque Angle Sensor Kit For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and suitably support the vehicle. Refer to Lifting   and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the tail lamp pocket as noted  from the original panel. Note: Clean and prepare the attaching surfaces for welding. Position the tail lamp pocket on the vehicle. Verify the fit of the tail lamp pocket. Clamp ...

© 2011-2026 Copyright www.ccruze.com