Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Front Hinge Pillar Body Sectioning (MIG-Brazing)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Front Hinge Pillar Body Sectioning (MIG-Brazing)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed

Installation Procedure
Cut the front hinge pillar body in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal th ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and She ...

Other materials:

Replacing LATCH System Parts After a Crash
WARNING A crash can damage the LATCH system in the vehicle. A damaged LATCH system may not properly secure the child restraint, resulting in serious injury or even death in a crash. To help make sure the LATCH system is working properly after a crash, see your dealer to have the system inspec ...

Engine Exhaust
WARNING Engine exhaust contains carbon monoxide (CO) which cannot be seen or smelled. Exposure to CO can cause unconsciousness and even death. Exhaust may enter the vehicle if: • The vehicle idles in areas with poor ventilation (parking garages, tunnels, deep snow that may block underbody air ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the service panel as noted from the original panel. Clean and prepare the attaching surfaces for welding. Position the roof rear header (1) panel on the vehicle. Verify the fit of the panel. Clamp the roof rear header ...

© 2011-2026 Copyright www.ccruze.com