Chevrolet Cruze Repair Manual: Quarter Outer Panel Sectioning (MAG-Welding)
Special Tools
- BO-6396 Bonding Pliers
- BO-6392 Flanging Tool Kit
For equivalent regional tools, refer to Special Tools
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.
Installation Procedure
Create 6 x 20 mm (4/16 x 12/16 in) slots for MIG-brazing along the edges
of the rear inner wheelhouse as noted from the original
panel.
Note: If the location of the original plug weld ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
Warning: Refer to Glass and She ...
Other materials:
Fuel Gauge
When the ignition is on, the fuel gauge indicates about how much fuel is left
in the tank.
An arrow on the fuel gauge indicates the side of the vehicle the fuel door is
on.
A FUEL LEVEL LOW message may appear in the Driver Information Center (DIC) and
a single chime sounds.
Here are four ...
Installation Procedure
Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing
(1).
Clean and prepare the attaching surfaces for spot welding and brazing.
Note: In MIG-brazing areas 50 mm (2 in) must be kept clear
of structural adhesive.
Apply structural adhesive to all attaching surfaces ...
Installation Procedure
Cut the front hinge pillar body in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed
to allow a gap of one-and-one-half-times the metal thickness at the
sectioning joint.
Create a 50 mm (2 in) backing plate from the unused portion of ...
