Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Body Hinge Pillar Lower Reinforcement Replacement (MAG-Welding)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Body Hinge Pillar Lower Reinforcement Replacement (MAG-Welding)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Cut the front hinge pillar body in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal th ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and She ...

Other materials:

Installation Procedure
Note: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1½ in). Drill 8 mm (5/16 in) for plug welding along the edges of the body rear end panel as noted  from the original panel. Clean and prepare the attaching s ...

Heated Front Seats
WARNING If you cannot feel temperature change or pain to the skin, the seat heater may cause burns. To reduce the risk of burns, people with such a condition should use care when using the seat heater, especially for long periods of time. Do not place anything on the seat that insulates again ...

Front Side Door Trim Replacement
Front Side Door Pull Handle Bolt Caution: Refer to Fastener Caution in the Preface section. Tighten 2 N·m (18 lb in) Front Side Door Inside Handle Bolt Finish Cap Tip Pull handle back to remove cap. Use suitable tool to unsnap. Front Side Door Inside Handle Bolt Tighten ...

© 2011-2026 Copyright www.ccruze.com