Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Body Lock Pillar Inner Panel Replacement (MAG-Welding)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Body Lock Pillar Inner Panel Replacement (MAG-Welding)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Prepare all mating surfaces as necessary. Align the body lock pillar outer panel reinforcement. Create 8 x 24 mm (5/16 x 15/16 in) slots for MIG-brazing upper (1) and lower (2). Cl ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR Syst ...

Other materials:

Installation Procedure
Install NEW stabilizer shaft insulators (1) to stabilizer shaft (2) so that the slit in the insulator is facing the rear of the vehicle. Install the insulator c 2. lamp to the insulator: 2.1. Position the clamp (2) over on the insulator. 2.2. Use two M8 bolts (1, 3) with 40 ...

Quick Info
Quick Info gives access to quick information on Audio playing, OnStar Turn-by-Turn route (if equipped), 5-day forecast, Nearby Fuel Stations, and Movie Show Times. To access, press Quick Info on the Home Page or the INFO button on the faceplate. Depending on the system and if the options are ...

Windshield Wiper Arm Replacement
Windshield Washer Arm Finish Cap Tip Use a small flat-bladed tool to remove finish cap. Special Tools BO-6626 Wiper Arm Puller For equivalent regional tools, refer to Special Tools. Windshield Washer Arm Nut Caution: Refer to Fastener Caution in the Preface section. Procedure ...

© 2011-2026 Copyright www.ccruze.com