Chevrolet Cruze Repair Manual: Lighting
Specifications
Headlights/Daytime Running Lights (DRL) Schematics
Interior Lights Schematics
- Brake Pedal Position Sensor Calibration
- Headlamp Replacement
- Headlamp Aiming
- Front Fog Lamp Replacement
- Front Fog Lamp Bulb Replacement
- Fog Lamp Aiming
- Backup Lamp Replacement
- Forward Lamp Wiring Harness Replacement
- Tail Lamp Replacement
- Exterior Lighting Systems Description and Operation
- Interior Lighting Systems Description and Operation
Horns
Specifications
Horn Replacement
Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.
Horn Nut
Caution: Refer to Fastener Caution in the ...
Brake Pedal Position Sensor Calibration
Calibration Criteria
Note: Do not apply the brake pedal during the brake pedal position
(BPP) sensor calibration procedure. Any movement of the brake pedal
during this procedure will cause the cal ...
Other materials:
Installation Procedure
Cut the front compartment front rail in corresponding locations to fit
the remaining original panel. The sectioning joint should be
trimmed to allow a gap of one-and-one-half-times the metal thickness at the
sectioning joint.
Create a 50 mm (2 in) backing plate from the unused porti ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR &nbs ...
Removal Procedure
Support the radiator and condenser from above using the
condenser tabs on each side.
Remove the lower steering intermediate shaft bolt (1).
Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assemblies. Refer to Tire and Wheel Remov ...
