Specifications

Body systems
Moveable Window SchematicsInstallation Procedure
Cut the front compartment upper side rail in corresponding locations to
fit the remaining original panel. The sectioning joint should
be trimmed to allow a gap of one-and-one-half-times the metal thickness at
the sectioning joint.
Create a 50 mm (2 in) backing plate from the unused ...
Rear Side Door Upper Hinge and Lower Hinge Replacement
Preliminary Procedure
Remove the rear side door. Refer to Rear Side Door Replacement.
Rear Side Door Hinge Bolt (Qty: 4)
Caution: Refer to Fastener Caution in the Preface section.
Tighten
25 N·m (19 lb ft)
Reart Side Door Hinge
Procedure
Adjust rear side door as needed. Refer ...
Installation Procedure
Create 6 x 20 mm (4/16 x 12/16 in) slots for MIG-brazing along the edges
of the rear inner wheelhouse as noted from the original
panel.
Note: If the location of the original plug weld holes can
not be determined, space the slots every 40 mm (1½ in).
Clean and prepare the ...